YAMAHA RHINO 660 TURBO KIT
Turbo Specialties has developed the Kit using a Garret Turbo and Gibson High Performance muffler. This easy to install Kit includes all parts necessary for the installation. Including an electric fuel pump, electric oil scavenging pump and Dynojet Carburetor jetting Kit.
More Photos
The Yamaha Rhino Turbo Kit includes the following:
- T20 Garrett Turbo w/adjustable actuator.
- Exhaust Manifold (cast iron)
- Exhaust Outlet
- Bolts, springs and donut gasket
- Heat Shield
- Oil Scavenger Pump
- Electric fuel pump
- Jets and Washers for carburetor
- Carburetor to turbo Piping
- Carburetor mounting hardware
- Muffler
- Charge Piping
- Wiring Harness for oil and fuel pumps
- Turbo rear Support Bracket
- Fuel Pressure Regulator
- Optional Boost, Air/Fuel Gauges available
- Fits the 2004-07 Yamaha Rhino 660 models
Installation Instructions Dyno Chart The Rhino was tested on a Dyno with the following results;
AT 6 POUNDS OF BOOST IT HAD 34 WHEEL HORSEPOWER.
AT 8.5 POUNDS OF BOOST IT HAD 38 WHEEL HORSEPOWER.
In our Experience at 6 Pounds of boost you can use High Octane Pump with either the stock CDI or aftermarket CDI with a low level of additional advance (i.e. 2 degrees)
Above 8 up to the maximum recommended 9 Pounds of boost we recommend using High Octane Racing Gas with any CDI.
One can receive the most benefit from the Turbo by using a modified CDI box to increase the RPM's, and this will help increase your Top Speed. It is best to use a CDI with a low amount of spark advance.
The use of a Sheave in the clutch will also increase the top Speed
Replacing the clutch with a modified clutch can give you up to 5 wheel Horsepower increase.
ENJOY THE UNLEASHED HORSEPOWER OF YOUR RHINO, BE SAFESKU: RH2001
© 2008 Mendoza's Offroad. All Rights Reserved.
